MBM Corporation Paper Drill 200 single spindle - Manual (Page 10)

10
METHOD NO. 2
1. Loosen the knob on the back gauge and set the margin you desire using the two scales embedded in
the rear corners of the table. Zero (“0”) on these scales indicates the center of the drill bit. Tighten the
back gauge scale knob to maintain its position.
2. Locate the product to be drilled against the back gauge scale. Center on the scale using the scale
graduations. Adjust the paper side stops to trap the material as in Method No. 1.
3. Move the table to align the “0” on the back gauge scale with the center of the drill bit.
4. With the pedestal pin in the same position as in Method No. 1, move a stop collar against the left side
of the pedestal pin and retighten the setscrew. The center of the material to be drilled has now been
established.
5. On the stop bar, move another stop collar to the distance required to equal the distance from the
center of the paper to the center of the first hole to be drilled. Make sure the measurement is from the
same sides of the stop collars. Other stop collar positions are determined and located in the same
manner.
6. The method of drilling is the same as in Method No. 1. Raise the pedestal pin and move the table to
the right. Lower the pedestal pin and move the table to the left until the pin “clicks” over the first
stop collar. With a ge ntle pressure against the left side of the table, depress the handle and release
slowly to drill the hole. Move the table until it “clicks” over the next stop collar and repeat until all
holes are drilled.