MBM Corporation Paper Drill 200 single spindle - Manual (Page 8)

8
TABLE SETUP AND DRILLING
Following are two methods for setting up the table to drill a particular hole pattern in the material.
The first is by the use of a template such as a piece from a previous job and the second is by
measurement.
ILLUSTRATION #5
METHOD NO. 1
1. Place a template of the material on the table such that the drill bit enters the hole furthest to the left
and the paper is centered on the table.
2. Adjust the paper side stops to trap and not allow lateral movement of the material on the table.
3. Loosen the knob of the back gauge scale and adjust the position of the back gauge scale to the correct
margin or back edge of the template.