MBM Corporation Paper Drill 200 single spindle - Manual (Page 12)

12
MODEL 200 BENCH MODEL DRILL
MAINTENANCE SCHEDULE
LUBRICATION AND INSPECTION
1. Every two weeks:
a. Remove the table by loosening the left end collar on stop bar assembly and rotating the table travel
stop down to clear the pedestal. Pull the table to the right until the table clears roller bearings.
Inspect the four traverse bearings for build-up on the outer race and lubricate the inner race with a
drop of light machine oil. Rotate the bearings to check for free rotation.
Replace the table in the same manner as removed and check the table traverse for free travel.
b. Stop pin - Lubricate the stop pin with light machine oil, working the pin up and down and rotating
a few times for proper lubricant distribution.
2. Every 30 days:
a. Pivot Assembly - Remove the back panel and work the handle up and down to determine all pivot
points in back portion of machine. Lubricate these points with light machine oil.
3. Every 12 months:
Remove back panel and lubricate the lift pin with a good grade of light oil.
CAUTION : KEEP FINGERS FROM BETWEEN LIFT COMPONENTS.
NOTE: Refer to your Trouble Shooting Guide for problem solving.
OBSERVE ALL SAFETY PRECAUTIONS DURING PREVENTATIVE MAINTENANCE
OF THIS MACHINE MODEL 200 BENCH MODEL DRILL