MBM Corporation Paper Drill 200 single spindle - Manual (Page 9)

9
ILLUSTRATION #6
4. Using the hex key provided, loosen the setscrews in the stop collars on the stop bar. Loosen only the
stop collars interior of the stop bar bracket.
5. With the longest end of the pedestal pin taper to the left (Illustration No. 6) locate a stop collar tight
against the left side of the pedestal pin and tighten the setscrew.
6. Move the table laterally to the next hole, align the drill bit, repeat step 5, and repeat until all holes are
aligned.
7. To drill, lift the pedestal pin and move the table to the original position, lower the pedestal pin
making sure it does not rotate, turn on the machine and depress the handle. To drill the next hole,
move the table to the left until the pedestal pin “clicks” over the next stop collar. Assert slight
pressure against the left side of the table to assure contact between the stop collar and pedestal pin.
Depress the handle, release and repeat this operation until all holes are drilled.