MBM Corporation Paper Drill 200 single spindle - Manual (Page 13)

13
TROUBLE SHOOTING GUIDE
PROBLEM:
Drill bit not concentric.
CAUSE Foreign material in chuck or on drill-plug.
CORRECTION: Inspect and clean.
CAUSE:
Drill bit bent.
CORRECTION: Replace.
CAUSE: Drill bit not inserted and/ or in chuck properly. Reinsert drill bit
CORRECTIONS: Correctly.
CAUSE: Chuck not tight to spindle.
CORRECTION: Tighten set screw.
PROBLEM:
Drill bit not drilling.
CAUSE: Drill bit plugged.
CORRECTION: Remove and clear chips. Check for other foreign matter.
CAUSE: Drill bit dull.
CORRECTION: Sharpen. (Follow factory cutting angle.)
NOTE:
In extreme conditions, drill chuck and/or chip chute may be plugged. Remove
drill, loosen chip chute, pull down, and clean. See Operation Manual.
PROBLEM:
Traverse table drags or skips during operation.
CAUSE: Roller bearings dry or damaged.
CORRECTION: Remove table, lubricate.
CAUSE: Table guides out of adjustment.
CORRECTION: Adjust.
CAUSE: Table damaged.
CORRECTION: Check table for damage. Repair or replace.
NOTE:
In order to maintain a smooth table operation, DO NOT sit on, lean on, or
force table out of alignment.