MBM Corporation CORNER STAPLER - Manual (Page 10)

5. Operation
5.1 Procedure and method
When using the stapler-puncher, also refer to the collator operation manual.
(1) Turn the power switch on.
(2) If stapling is not required, press the
PROGRAM key on the collator operation panel to
switch to Program mode.
( PROGRAM lamp will light)
(3) Press the STAPLE/1 key on the operation panel.
Stapling mode On: Lamp is lit.
Stapling mode Off: Lamp not lit.
Stapling is designed to be On with nothing
programmed after the collator power switch is on.
(4) Load the paper on the collator stations to be used;
adjust the stacking table guides left and right, slide
poles, and stacking slide guide to fit the paper size.
Caution!
Set the paper neatly and adjust it to fit the paper
feed guides. If the paper is not set properly, its
corners will not be uniform at the time of
stapler-puncher processing.
9