MBM Corporation CORNER STAPLER - Manual (Page 17)

7. Troubleshooting
7.1 Nature of problem and corrective action
Status Possible Cause Corrective Action
Connectors (two) linking collator and
staple-puncher improperly attached Properly attach them. Cannot switch to
stapler-puncher
Stapler-puncher circuit beaker off Push circuit breaker button.
Paper not loaded neatly on each station Place paper in order, then set the guides close to
the paper.
Paper deformed, curled or damaged
Processing paper soon after being
printed
Correct curling, etc.; do not use deformed or
damaged paper.
Let ink dry for at least a week before
processing.
Copied paper just after leaving copier Allow enough time for static electricity to
dissipate before processing.
It is advised that, if the edges of paper to be
collated (four sides) is wiped with wet towel, etc.,
static electricity can be removed.
Paper of odd specifications used Use specified paper only.
Paper size shift lever improperly set Adjust lever to paper size.
Paper loaded on stations not of uniform
size Use paper of the same size.
Paper not neatly
delivered
Stapler-puncher incorrectly attached to
the collator Install it firmly so it does not wobble.
Stapler-puncher incorrectly attached to
the collator Install it firmly so it does not wobble.
Foreign matter where paper passes Remove foreign matter.
Paper jams when
paper enters the
stapler-puncher
from the collator
Paper curled or deformed Correct curling; do not use deformed paper.
Paper curled upward or deformed Correct curling; do not use deformed paper.
Stapler-puncher incorrectly attached to
the collator Install it firmly so it will not wobble.
Paper jams when
returning to the
collator from the
stapler-puncher
Foreign matter where paper passes Remove foreign matter.
Staple cartridge improperly set Set cartridge properly.
Staple sheet fails to reach the proper
position Hit Empty Stapling.
Staples stuck at edge of cartridge Correct it to the normal position.
Empty Stapling
Staple cartridge improperly set Set it properly.
Stapling mode not programmed Press the MODE and STAPLE/1 keys.
( STAPLE/1 lamp will light)
Connectors (two) linking the collator
and stapler-puncher loose or undone Connect them firmly.
Stapler-puncher circuit breaker off Push the circuit breaker button.
No stapling
Foreign matter in the drive portion of
the stapler Remove foreign matter.
16