MBM Corporation TRIUMPH 5560 - Manual (Page 17)

- 17 -
T 09.50
T
Operating elements
A - Safety light beam
B - Safety two-handed control system
clamping and cutting
C - Air table On-Off
D - Backgauge control
E - Foot pedal
F - Main switch
G - Hand-wheel for backgauge setting
H - Blade locking
I - Backgauge
J - Side lay left and right
K - Clamp pressure
L - Clamp pressure adjustment
Start machine
• Main switch F to position "I".
Start screen appears
The following functions are changeable:
Brightness
CM/INCH
Touchtone ON/OFF
Language
•
Press START M backgauge I moves to
the rear and searches for the reference
position, wait until a measurement
is shown in the display D
IDEAL 5560 = 57 cm, 22.44 inches
• The DIN measurements in cm
(A3, A4, A5, A6) and in inch (LD, LG, LT, hLT)
are recallable with the respective buttons.
Warning!
Before storing or cutting a measurement
please check if the correct measurement scale
(cm or inch) see above is stored.
For information on how to store see picture
below left
Is shown on the screen see N .
After 30 minutes the screen switches to
energy-saving mode
The screen is reactivated by touching the
keypad area O .
• Operation •