MBM Corporation TRIUMPH 5560 - Manual (Page 21)

- 21 -
T
• Operation •
Adapting a program when the printer’s
imprint deviates
• Press PRG. RUN "Load program no."
appears
• Enter program number 01 ... 99, and with
2 x Enter proceed to Step 1
• Correct the cutting position of the
backgauge with the hand-wheel
• MODIFY W appears on the screen and the
measurement flashes
• To store press MODIFY
• Release a cut and turn the paper
• If the printer’s imprint deviates it can be
corrected during the first two cuts via the
hand-wheel – see above
• Correction is only possible during the first
two cuts
• After leaving the PRG. RUN mode the
original data is stored again.
Delete a step
• Press PRG. EDIT
• Enter program number, confirm with Enter
• Select program step with the arrow keys
b
and
j
• Scroll with STEP until "Delete step no."
appears, Press 2 x Enter .
Insert a step
• Press PRG. EDIT
• Select a program, confirm with Enter
• Scroll with STEP until "Insert step no."
appears
• Enter insert position e.g. 02
• Confirm with Enter
• Enter a measurement
• Store the measurement with
• The cutting position can be shown on the
screen with the arrow keys
b
and
j
.
Changing a program step
• Press PRG. EDIT
• Select a program, confirm with Enter
• Scroll with STEP until "Load step no."
appears
• Enter step position e.g. 03
• Confirm with Enter
• Enter a new measurement, Store the
measurement with .