MBM Corporation TRIUMPH 5222 DIGICUT - Manual (Page 21)

-21 -
5222 DIGICUT
A
Eject function
If button
j
O is pressed instead of button S Q ,
after inserting the measurement S , the
backgauge will advance forwards so that
paper can be removed. Finally the backgauge
moves to the last setting.
Adjust the eject-dimension
• Press p , hold, and press T e
on
display.
• Insert the desired dimension.
(Standard is 20 cm).
• g Store dimension.
• p + s Escape the program mode.
Program buttons
b
and
j
programs
Press p
, hold, and press
b
(
ö
appears on
the display) or
Press p , hold, and press
j
(
Ü
appears
on the display)
•
Enter the desired dimension (For example:
29,7 cm x 21 cm can be entered for DIN A4)
•
g Store dimension.
Display in cm or inch
•
Press i display changes between cm
and inch (see page 19).
Cutting counter
• Press i and hold and press 0 .
number of cuts are shown.
Press c twice to delete the number of cuts.
Press s to escape the cutting counter.
Cutting activation
Warning!
• Run backgauge to the front for turning the
paper stack.
• Do not interrupt the upward movement of the
blade by performing switching procedures.
• Release blade only when LED "S" has gone
out.
• The safety area (A) must be free.
• Blade must always be at the top and be
covered by the clamp. Do not touch the blade.
Risk of injury!
• Press both buttons of the two-handed control
system simultaneously and keep them
pressed until the paper is completely cut.
• Operation •