MBM Corporation TRIUMPH 5222 DIGICUT - Manual (Page 33)

-33 -
5222 DIGICUT
3.
A
2.
1.
Lower the blade by pressing both cutting
buttons (1.). Keep one button pressed and turn
off the main switch (2.).
With the special wrench (A) the 3 eccentrics
should be screwed down (3.)until the paper is
cut along the entire length of the blade (The
blade must remain parallel, not too deep into
cutting stick).
Turn main switch to position "I" (1.). Blade will
return to upper position. Tighten the blade
screws (2.) firmly.
• Blade and cutting stick replacement •