MBM Corporation TRIUMPH 5222 DIGICUT - Manual (Page 28)

- 28 -
5222 DIGICUT
IDEAL 5222 DIGICUT
B
A
A
ok
ok
Zacisk Zacisk Zacisk Zacisk Zacisk Nóż Nóż Nóż Nóż Nóż
The 3 eccentrics are now exposed and should
be turned counter clockwise to position "0"
with the special wrench and attachable
extension pipe (A) (in the tool set). The slot
must correspond to position "0" (B).
It is essential that this procedure is
performed so that the knife stands in the
correct position, see A. (If this process is
not performed the knife could cause
injury).
Remove the special wrench and turn on the
main switch until the blade returns to the home
position.
• Blade and cutting stick replacement •
Clamping Blade
OK
OK