MBM Corporation iCREASE PRO - Manual (Page 14)

ADJUSTING THE FEED RAIL
The feed rail on your icreasePRO is designed to adjust easily in case of a problem with
crooked feeding. By loosening the feed rail screw and nut on the front or rear of the rail
you can move the rail for sqaureness.
LOADING THE FEEDER
Take one piece of paper and slide it along the rail ensuring it is square along the entire
rail. Gently slide the paper until the rollers take the sheet then release. Make sure to
allow the sheet to run completely through the machine before running the next sheet.
Repeat until job is complete.
FEEDING NOTES
• When set properly, the feed is very efficient and flexible. When neglected it can
become very frustrating to run even the simplest job. The adjustments
previously discussed are very important.
• The icreasePRO is capable of running 20lb. single sheets up to 16 point. It is also
very capable of handling gloss, coated, and even laminated stocks. Its flexibility
is directly related to the operator’s experience.
• To clean the rubber rollers, use only water on a clean cloth. Wipe the rollers in
the direction of the ribbing while turning them by hand.
CHECKING THE SENSORS
1. Turn machine power on and allow screen to turn on
2. There should be 2 lights on the sensor a green indicating power is getting to the
sensor and orange that is the reflecting signal. If both lights are not on there is a
problem and must be fixed before you are able to run.
3. Make sure the sensor reflector tape is located on the base plate and the red beam
from the sensor is hitting the tape. If not remove the non operator side cover and
loosen the screw on the sensor bracket and adjust the beam until it is on the tape and
both lights are on.
4. If all above steps work correctly sensor is working properly, if not, contact the MBM
Corporation service department.
11