MMD Equipment 40S-8B1 - Manual (Page 15)

3. Installation
3-2
A050506
SG0103-1
 In case that the unit is installed inside any
tunnel, make sure to provide fresh air and
ventilate it.
 In this case, make sure to extend the
exhaust fume pipe outdoors, and also make
sure to prevent any leak from any
connection pipes. In case that the unit is
operated under exhaust air pressure, make
sure to install the exhaust pipe to be
supported.
 Never locate the unit with the exhaust muffler facing any
private house:
 As the exhaust fume (gas) from the engine is poisonous,
never direct it to any other persons passing by.
 The machine has to be installed on dry, firm, and level
area.
 Avoid installing the machine in a place such as a
damp place or a place where puddles are apt to be
formed after rain. Such installation could cause
electric shock.
 When installing the machine at the sea shore or on a
ship, make sure that the machine should not be
exposed directly to sea water.
 When installing the machine at a sandy place, make
sure that exhaust from the generator or radiator does
not blow the sand up in the air, or into the machine.
 In case that the unit has to be installed inevitably on
any rough and uneven ground; it is necessary to
insert square wooden bars under the unit for levelling it.
Installing the unit st such poorly-ventilated place
○
×
Exhaust fume
extension pipe
Exhaust fume
(or gas)
Suction air is fed
by air blower.
Exhaust
How to locate the unit
×
Private house
○
Installation
A050505-1