MMD Equipment 400S-6B1 - Manual (Page 10)

1.Safety
1-7
H990432
H990432
It is recommended to use a lamp with safety guard fitted
where the site is dark. Operating the machine gropingly or by
relying on one’s intuition could cause unexpected accidents.
Any lamps without safety guard are not recommended since
they can be broken and they could ignite flammables such as
fuel, etc.
Be sure to stop the engine, and let the coolant water suffi-
ciently cool down before draining it.
If the drain valve is opened before the coolant water is cooled
enough, hot water could jet out, and it could cause scalding.
After stopping the engine, wait 10 to 20 minutes until the engine
oil cools off. Then check the level of the engine oil, or refill or
drain the oil.
During operation or immediately after the engine stops, its oil
is extremely hot and pressurized, so it may jet out when the
cap is loosened. Be careful not to scald yourself from it.
When washing the machine, cover the control panel, generator and its electric parts to prevent them
from being exposed to splashing water and avoid possible decrease in electrical insulation or other
troubles to the machine.
Dust, sand and dirt accumulated inside control panel could cause malfunction or
trouble of the instruments. Clean them by blowing compressed air.
Waste liquid from the machine contains harmful material. Do not discharge it onto the ground or into
the river, lake or sea. Such material will pollute the environment.
Be sure to use a container to hold the waste liquid from the machine.
Be sure to follow the designated regulations when disposing of oil, fuel, coolant (antifreeze), filter,
battery or other harmful materials.
Lighting apparatus
Opening coolant water drain valve
Refilling or draining of engine oil
Caution of the cleaning
Disposal of waste liquid, etc.
TR0206