MMD Equipment 400S-6B1 - Manual (Page 35)

4. Operation
4-12
PK0028
<Automatic operation>
Inspection and maintenance prohibited during automatic operation
Never put your hands close to the interior of the machine,
because the generator can be started when start signal
functions even while the machine is in stop position.
Before starting inspection and maintenance job, make sure to
place the selector switch of automatic starting panel to “MAN”
position and to hang the tag “Under inspection and
maintenance”.
Remove the battery cathode cable terminal.
Pull out the starter key of the generator and the inspector
himself should keep it during inspection and maintenance job.
neglect and/or ignoring the above items could cause a serious
accident to other persons standing close by the machine when any other person than the inspector
himself starts the machine.
1. Cable connection method of remote control switch
The remote control terminal“1”is provided inside the output terminal. Perform cable connection as
shown below for remote control operation of the machine. For this cable connection job, make sure to
remove the battery cathode cable terminal.
While the machine is in stand-by conditions during automatic operation, battery discharge occurs.
Make sure to charge battery, operating the battery charger.
A040273-3
1
Install the battery charger