MMD Equipment 150S-6A6 - Manual (Page 7)

1.Safety
1-4
1.2 Caution during Operation
Never touch the output terminals and interior of control board
Never touch the output terminals during operation.
Notice that the voltage of several hundreds volt is applied to
the output terminal.
When removing or connecting a connecting cable for changing
load, be sure to switch OFF the circuit breaker, remove the
starter key from the starter switch, then carry out a work. The
operator must keep the key during operation.
Neglecting the cautions mentioned above, and a third party
starting the machine during operation may cause serious
accidents such as electric shock.
Never touch the interior of the control panel during operation.
Notice that the voltage of several hundreds volt is applied to
the interior of the control board.
When checking or operating the interior of control panel, be
sure to stop the machine, remove the starter key from the
starter switch, then carry out a work. The operator must keep
the key during operation.
H990208
Hands off from rotating parts and belts
Keep hands off from the rotating portion or belts while running.
It could cause serious injuries if hands should be caught in.
TR0304
Do not remove radiator cap during operation
Do not, under any circumstance, open the radiator cap while
running or immediately after stopping operation. Otherwise
high temperature steam jets out and this could cause scalding.
H990432