MMD Equipment 150S-6A6 - Manual (Page 8)

1.Safety
1-5
Do not touch hot parts
Never work nearby hot portions of the machine while it is
running.
Do not touch hot portions of the machine while inspecting the
machine when running.
Such parts as engine, exhaust manifold, exhaust pipe, muffler,
and radiator are especially hot, so never touch those parts,
because it could cause scalding.
Coolant water and engine oil are also very hot and dangerous
to touch. Avoid checking or refilling them while the unit is
running.
H990432
Fire prevention
Do not, under any circumstance, bring lit cigarettes or matches
near such oils as diesel fuel oil, and engine oil, etc.
They are extremely flammable and dangerous, so be careful
when handling.
Refilling oils should be done in an outdoor well-ventilated
place.
Refuel after stopping the engine, and never leave the fuel
nearby the machine. Do not spill. It may cause a fire. When it is
spilt, wipe it up completely.
Such parts as muffler and exhaust pipe can be extremely hot.
Remove twigs, dried leaves, dried grass and waste paper, etc.
from the exhaust outlet of the muffler.
Keep a fire extinguisher available by the machine in case of
unexpected fire.
D004
Draining during operation prohibited
Do not, under any circumstance, open the portions below
during operation.
Coolant drain valve and plug
Engine oil drain plug
Unbalance of overload and load
Reduce the load when the circuit breaker actuates frequently during operation.
When a single-load is used, check the current of each phase, and adjust the load so that each load
value should be balanced.
If the above procedure is neglected during operation, the generator could be burned or it could cause
a fire. If the machine is operated with the frequency lower than the rated frequency, it could cause the
generator or load motor to be burned.
H990433
PK0028