Montigo H34DF - Manual (Page 20)

H*34DF Indoor Gas Fireplace
Page 20 XG0146 - 150204
Installation
Installing the remote On/Off Wall Switch
The H*34DF* gas valve may be connected to a wall switch. Do NOT
connect any external power to the remote switch. The valve will
generate its own power on a millivolt circuit or will draw its power from
an AC Connection inside the fireplace, depending on the model of the
unit. Use only low voltage wire, and DO NOT connect any external
power to the remote switch.
Refer to Figure 20, 21, or 22 for wiring requirements.
NOTE: The switch location must not exceed 30' from the fireplace.
NOTE: If any of the original wire supplied with the appliance
is replaced, it must be replaced with the same type,
or its equivalent.