Montigo H34DF - Manual (Page 28)

H*34DF Indoor Gas Fireplace
Page 28 XG0146 - 150204
Installation
Installing the HC34DF* Log Set (Previous model HD34DF*)
(Part # LGS44P)
Installing the Logs:
The HC34DF* is supplied with a seven piece ceramic fibre logset. Unpack
the logs and handle them very carefully.
Step 5. Place the left two logs, and the centre log shown below in
figure 29d.
Step 4. Place the top logs from left to right in the order as shown in
Figure 29a. These logs balance in the grooves of the base logs
and do not lock into place.
Figure 29a. HC34DF's seven piece logset.
Figure 29b. Rear Log placement.
Figure 29d. Left and Center log placement.
Figure 29e. Right log placement.
Step 6. Place the right two logs as shown in figure 29e.
Figure 29c. Front Log placement.
Step 2 Place the Rear Log in position at the back of the fireplace as
shown in Figure 29b below.
Front Log
Rear Log
Upper Logs
Step 3. Place the Front Log in position just behind the black grate as
shown in Figure 29c below.
Step 7. Start the fireplace. If the flame appears satisfactory, replace
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.
Step 1. Remove the glass door as described in the previous instruction.
If logs are not placed properly, excessive sooting will result.
NOTICE
Base Log