Montigo PVVEX58-300 - Manual (Page 6)

PVVEX58-300 & PVVEX510-300 Horizontal Power Vent
Page 6
XG0518 - 070714
Step 4: Unscrew 6 screws securing the control cable cover and
remove it.
Figure 2d. Unscrewing control cable cover
Figure 2e. Removing control cable cover
Figure 2f. Removing strain relief plate.
Step 5: Unscrew 2 screws securing strain relief plate and remove it.
Strain Relief Plate
Figure 2g.
Step 6: Loosen nut on the strain relief of the control cable. Pass
control cable through slot in rough in box making sure the nut stays is
on the opposite side of the rough in box as the strain relief.
Figure 2h.
Step 7: Push the strain relief through the hole in the roughin box.
Figure 2i.
Step 8: Reinstall the strain relief plate. Make sure the strain relief nut
is above the strain relief plate.
Installation