Onwa Marine Electronics KP-823MKII - Manual (Page 11)

I
Power on :
Pressing and holding the Power key till it beeps turns the power on, the screen
displays pictures.
Power off
Pressing and holding the Power key till it beeps turns the power off, it displays
the countdown screen then disappears after 5 seconds.
Adjusting the brightness and contrast
Shortly pressing the Power key displays "brightness" and "contrast", press
up/down Arrow keys or the Power key to adjust brightness, use the
right/left Arrow keys to adjust the contrast. See Figure 11
2.2.2. Establish waypoints and position storage
Establish a new waypoint on plotter screen by cursor :
Press the MODE key to enter Plotter screen, press the Arrow keys to move
the cursor to the position which required to establish the waypoints, and press
ENT key, then press ENT key again, this equipment will automatically estab-
lish and number the new waypoint . See Figure 12
nput the longitude and latitude to establish a new waypoint
Press key MENU twice to enter the main menu, move the cursor to the "Point"
column. Press MENU key and move the cursor to the "New WPT" column,
then press ENT key. Displays the new waypoint screen, it's ready to edit the
waypoint. Move the cursor to the "name" column, press ENT and input the way-
point number or symbol, press the ENT key again to finish. Then move the cursor
to the "position" column,press ENT and input the latitude and longitude, press
ENT to finish.
2.2 Operation
9
Figure 11 Figure 12
2.2.1. Turning the power on/off, adjusting the brightness and the contrast