Onwa Marine Electronics KP-823MKII - Manual (Page 27)

The relevant data (including the time, place, the relevant ship s information,
etc.) will also be saved by the display terminals, it can be the basis of an-
alysis in the event of any accident.
'
4.9 Entry/Departure setting
The Entry/Departure setting is for temporarily shut down or restart the co-
llision alarm, when entering the port the collision alarm will be temporarily
closed, when leaving the port the collision alarm will be opened. There are
two ways for Entry/Departure setting
1) Press the MENU key at the Radar window, and select " " or
" " . See figure 43
2) Press the NAV key at any window, and select " " or " " .
See figure 44
In Port
Out Port
In Port Out Port
25
4.8 Emergency alarm
The information of the emergency alarm received is displayed on the bottom right
corner. The emergency alarm is always available and can not be deleted, if the em-
ergency alarm information is not read, after exiting the alarm menu, the "emergency
alarm" window will pop up a little latter. The warning ship displayed on the Radar
will be yellow and flashing. See Figure 42
Figure 42
Figure 43 Figure 44