REMKO RVT 263 DC - Manual (Page 22)

Key functions
A symbol is shown on the display to indicate that
the settings are being transferred.
"Auto" mode
Make sure that the indoor unit is connected to the
power supply, and is switched on.
The operating mode indicator on the display of the
indoor unit begins to flash.
1. Press the "MODE"key to select "Auto" mode.
2. Press the "UP/DOWN"key to set the desired
temperature. The temperature can be set
between 17 and 30°C, in increments of 1°C.
3. Press the "ON/OFF"key to switch the air
conditioning unit on.
1
3
2
Fig. 21: "Auto" mode
– In "Auto" mode, the air conditioning unit is
able to logically select between the
"Cooling" , "Recirculation" and "Heating"
modes, specifically by detecting the differ-
ence between the actual room temperature
and the temperature set on the remote
control.
– In "Auto" mode, it is not possible to set the
fan speed. This is already controlled auto-
matically.
– If "Auto" mode is not comfortable enough
for you, you can also select the desired
mode manually.
"Cooling", "Heating" and "Recirculation" mode
Make sure that the indoor unit is connected to the
power supply, and is switched on.
1. Press the "MODE"key to select from oper-
ating modes "Cooling", "Heating" or "Recircu-
lation".
2. Press the "UP/DOWN"key to set the desired
temperature. The temperature can be set
between 17 and 30°C, in increments of 1°C.
3. Press the "FAN"key to select from the four
fan speeds (Auto, slow, medium and fast).
4. Press the "ON/OFF"key to switch the air
conditioning unit on.
1
4
2
3
Fig. 22: "Cooling", "Heating" and "Recirculation"
mode
– In "Fan" mode, the temperature setting is
not shown on the remote control, and it is
not possible to check the room tempera-
ture. In this case steps 1, 3 and 4 can be
carried out.
"Dehumidification" mode
Make sure that the indoor unit is connected to the
power supply, and is switched on.
The operating mode indicator on the display of the
indoor unit begins to flash.
REMKO RVT...DC
22