Scotsman RS160 - Manual (Page 7)

Installation: Scotsman CM Cuber
1. Make sure the counter the dispenser is placed
on is structurally able to hold the combined weight
of the dispenser, ice and ice machine.
2. Install the dispenser.
3. Remove the dispenser cover (save it - it will be
needed if the ice machine is removed).
4. Place stainless steel adapter sleeve onto the
top of the dispenser.
5. Using the tube of sealant from the kit, place a
bead of sealant onto the top edges of the area on
the adapter where the ice machine will go.
6. Place a bead of sealant onto the inside and
outside seams where the dispenser and adapter
meet.
7. Using a mechanical lift, hoist the ice machine
onto the dispenser, center left to right and align
flush to the back.
8. Install a bin thermostat bracket assembly onto
the underside of the CM ice machine.
Note: Thermostat bracket only required by CM250,
CME250, CM500, CME500, CM650 or CME650.
9. Fasten together at the back of the machine
using bolts from the ice maker and mounting
straps from the kit.
10. Place the front cover plate onto the dispenser
in front of the ice machine.
RS160 and RS220
June 1995
Page 7