Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 12)

Version 4.00 Page 12
The system will respond by saying: "Menu,
enter number". At this point you have 6 MENU
choices.
! Menu Choices
1 1 1 1=Enter a Notification Number
In this mode you can verify, change, disable,
enable or erase any, or all, of the 16 alert notification
numbers in the system.
The unit first states the entry number (1-16),
followed by the TYPE (Pager or Voice), then it tells
you the current number, followed by instructions, as
follows:
"Entry 1, Voice, 7866186, 0 to Disable, 1 to
Change, 3 to skip, 7 to Backup."
The system will indicate a blank number by
saying "New".
To ERASE a number, enter 1 1 # 1 1 # 1 1 # 1 1 #.
To EXIT back to the Remote Menu, press * * * *.
The default PAUSE BEFORE NEXT DIAL is,
immediate (00) after a voice call, and 5 minutes (05)
after a pager call. You can enter a user defined
PAUSE by pressing
* * * * within 2 seconds after
pressing the # # # # on entering a new number. The
entry is in minutes and MUST be 2 digits.
• Example:
5 minutes is entered as: 0 5 # 0 5 # 0 5 # 0 5 #.
5 5 5 5=Record a New Outgoing
Message
After the tone, start dictating your new
outgoing message. When you are finished press * * * *
to stop. If the unit detects 4 seconds of silence, it
will automatically end the recording. The system
will play the message and return to the Remote
Menu automatically. Pressing
* * * * during the
message playback will return the system to the
Remote Menu.
6 6 6 6=Outging Message Test
The outgoing message will play back then
return to the Remote Menu. Pressing * * * * during
playback will return the system to the Remote Menu.
8 8 8 8=Start Group/Default Box
This parameter is used ONLY in On
Call/Voice_Box and Cycle Alert Modes.
In On Call mode, if the caller dials an 8 8 8 8, then
this parameter selects the group to be notified. This
allows you to keep the same outgoing message, but
allows you to change the person(s) who will be
notified with one easy step.
In Voice Box mode, this parameter shows the
default voice mail box that will be used if the caller
doesn’t select any option at the main message.
In Cycle mode, this parameter controls who is
the FIRST to be called. If the message is not
received, the system will continue dialing in
sequence. In this mode the system will eventually
call all programmed notification numbers until the
message is received.
0 0 0 0=Answer Mode Toggle
This parameter lets you switch the system
between Idle Mode and Answer Mode. NOTE:
When the system is in voice box mode or On Call
mode, you will only be allowed to remotely place
the unit into Answer Mode, not to Idle Mode.
Pressing 0 0 0 0 toggles between the two modes;
first press “Enables” (changes to Answer Mode),
next press “Disables” (changes to Idle Mode).
* * * *=Disconnect
You can force disconnect by pressing * * * * from
the Remote Menu. The unit will automatically
disconnect on time out.
Notification
Dialing