Power up, Diagnostic test, Idle mode – Skutch Electronics BA-1000-A V4.00 Technical Reference Manual User Manual
Page 7
Version 4.00
Page 7
FCC No: AP494N-64812-MA-E
RINGER EQ.:0.0B
USOC No (Jack type) RJ-11, RJ-12, or RJ-13
(See telephone connection)
Power Up
To power the unit up;
1) Make sure that the Microphone is disconnected
from the BA-1000-A.
2) Connect the supplied POWER ADAPTER to the
POWER jack on the rear panel of the BA-1000-
A. This MUST be done before the POWER
ADAPTER is connected to 115VAC power.
3) Now connect the POWER ADAPTER to a
115VAC 60Hz power outlet.
!
Diagnostic Test
Every time the BA-1000 is powered up, it
performs a series of diagnostic tests as follows:
The display shows the initial splash screen:
- Initializing -
-- Zip Drive --
The display shows the initial splash screen:
Copyright 1999
Skutch Elec, Inc
Then it sets up the phone line circuits, showing:
- Initializing –
Phone line CODEC
Then it sets up the mic circuits, showing:
- Initializing –
Microphone CODEC
Then the system will calibrate the microphone
input. Make sure the no audio source or microphone
is PLUGGED in while the system says:
Remove MIC While
Calibrating!
After 8 seconds, the system will show:
Now POWERING UP
primary systems.
Then the system will show:
- Initializing -
-- Zip Drive --
Then it will test the ZIP drive and show the
following:
Testing Zip Disk
– Please Wait -
Then it will test all the files on the system,
showing:
-Testing Files-
- Please Wait -
The system will update the number in the top
right to show the current file being tested. When all
tests are done the system will show the following:
>System On Line<
100% Functional!
Then the system will put you at the MENU, as
follows:
--Idle--Ver 4.00
11/01/01 08:00am
Idle Mode
In this mode the BA-1000-A will not answer
incoming telephone calls. You MUST be in IDLE
mode to initiate any of the following:
"
To
TEST
or
RECORD
your outgoing
message.
"
To
PLAY CALLS
locally.
"
To enter
AUTO ANSWER
mode.
"
To enter
POWER DOWN
mode.
"
To
program NOTIFICATION Phone
Numbers
.
"
To change the
parameters.
To return the unit to IDLE mode from other
modes simply press
~
~
~
~.
While in Idle Mode, you can call the system to
remotely change it to Answer Mode; the system
will answer after the 10
th
ring, then just go into
Remote Mode
to change the state.