Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 18)

Version 4.00 Page 18
Sense Level= 12
01 to 20 #=Next
Enter the level from 01 01 01 01 to 20 20 20 20 then
press then release # # # # to go to return to the Total
Calls screen. You can press then release
~
~ ~ ~ to return to the Total Calls screen.
! Dial Mode= Tone
This option allows you to select touch tone
dialing or pulse dialing. Some phone lines still only
allow pulse dialing for outbound calls; in these areas
you can change the system to pulse dial mode. The
display looks as follows:
Dial Mode= Tone
1=Change #=Next
Press then release 1 1 1 1 to toggle between Tone
and Pulse; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! CPC Detect= On
This option allows you to disable the system’s
ability to detect the CPC disconnect pulse sent by
some telephone companies. When set to On, the
system will, on detecting a CPC pulse, hang up on
the current phone call and log it as a Hang Up.
When set to Off, it will ignore any CPC pulses sent.
The display will look as follows:
CPC Detect= On
1=Change #=Next
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! Dial Tone HU= On
This option allows you to make the system
hang up on any caller when it detect a return Dial
Tone during the message record phase, when On.
When set to Off, it will ignore any Dial Tone
received. The display will look as follows:
Dial Tone HU= On
1=Change #=Next
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! Talk Limit= 12
This option tells the system how many seconds
of continuous talking it can accept, before it
considers the call a Recorded Message. For this
option, 1 = 10 second. A setting of 25 is unlimited
talk time. The display will look as follows:
Talk Limit= 12
01 to 25 #=Next
Enter from 01 01 01 01 to 25 25 25 25 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to return to the Total Calls
screen.
! Pause Timeout=35
This option tells the system how many seconds
of silence it needs in order to stop recording and
continue with the outgoing message. For this
option, 1 = .1 seconds. The display will look as
follows:
Pause Timeout=35
15 to 80 #=Next
Enter from 15 15 15 15 to 80 80 80 80 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to return to the Total Calls
screen.
! Voice Trigger=02
This option tells the system how much time is
needed to trigger a valid voice response. If the caller
talks less than this setting, the system will not allow
any alert trigger for this caller. For this option, 1 = 1
second. The display will look as follows:
Voice Trigger=02
01 to 60 #=Next