Alert mode= tone – Skutch Electronics BA-1000-A V4.00 Technical Reference Manual User Manual
Page 14
Version 4.00
Page 14
Play Only= Off
1=Change #=Next
Press then release
1
1
1
1 to toggle between Off
and On, press then release
#
#
#
# to proceed to the
next option. You can press then release
~
~
~
~ to exit setup mode.
!
Alert Mode= Tone
This controls how the BA-1000-A defines an
Urgent Call.
The display will look as follows:
Alert Mode= Tone
0 to 3 #=Next
Press then release
0
0
0
0 for All voice calls, 1
1
1
1
for touch tone 8 calls,
2
2
2
2 for on call mode calls,
3
3
3
3 for cycle calls, or press then release #
#
#
# to
proceed to the next option. You can press then
release
~
~
~
~ to exit setup mode.
"
0=All
In this mode, the BA-1000-A will Alert Dial on
all calls that leave a voice message. Calls that have
no voice will not be triggered.
"
1=Tone
In this mode, the BA-1000-A will Alert Dial
only if it detects that the calling party has dialed a
touch tone
8
8
8
8.
"
2=OCall
In this mode, the calling party presses a touch
tone
8
8
8
8, then the group defined by the
START
GROUP
parameter, in SETUP mode, will determine
the group to be alerted (the system will only dial the
numbers within that group, the ON Call group).
The BA-1000-A can store up to eight different
notification telephone numbers for each group with
up to 16 different groups. The following outgoing
message describes the operation the best:
"Thank you for calling the ABC Medical
Group. I'm sorry but we are not available to
answer your call at this time. Please leave your
name, telephone number, and a short message and
we will call you back as soon as possible. If you
need immediate assistance please leave your
message then dial an 8. Thank you."
The following shows the Notification Entries
that are used for each Tone Response.
Group/Box #
Notification Entries
1
1-8
2
9-16
3
17-24
4
25-32
5
33-40
6
41-48
7
49-56
8
57-64
9
65-72
10
73-80
11
81-88
12
89-96
13
97-104
14
105-112
15
113-120
16
121-128
When you play back messages, while in
OCALL mode, the user must specify which group he
wants to hear by entering his specific
PIN
number
specified in the
Vbox PINS
.
"
3=Cycle
This mode works the same as the
2=Tone
mode, except that the starting alert notification
number is controlled by the
START GROUP
parameter in the SETUP mode as follows:
Group #
Notification Entries
1
1-8
2
9-16
3
17-24
4
25-32
5
33-40
6
41-48
7
49-56
8
57-64
9
65-72
10
73-80
11
81-88
12
89-96
13
97-104
14
105-112
15
113-120
16
121-128