Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 15)

Version 4.00 Page 15
! InRing Delay= 02
This controls how many rings it takes before
the BA-1000-A answers the phone. The entry can
be from 00 to 12. 00 is Toll Saver mode, which
answers after the third ring if no Urgent or New
messages are on the system, and answers after the
first ring if the system has an Urgent or New
message on it. The display will look as follows:
InRing Delay= 02
00 to 12 #=Next
Enter from 00 00 00 00 to 12 12 12 12 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to exit setup mode.
! Redial Limit= 20
This is the number of redials that the system
will attempt if the Urgent message has not been
played. The selection can be from 00 to 99. 99 is
Unlimited. The display will look as follows:
Redial Limit= 20
00 to 99 #=Next
Enter from 00 00 00 00 to 99 99 99 99 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to exit setup mode.
! Start Group= 01
Also appears as Default Box= 01.
This parameter is used in ALERT MODE
2 ,
Voice Mail Box mode and ALERT MODE 3 . In
either ALERT MODES 2 or 3, when the caller dials
8
8 8 8, then the group, defined by this parameter, will
Alert dialed. In Voice Mail Box mode, the display
will show Default Box= 01; and, if the caller
doesn’t select a mail box number at the main menu,
he will be transferred automatically to the box
specified by this number.
The following shows the Notification Entries
that are used for each Tone Response.
Start Group Notification Entries
1 1-8
2 9-16
3 17-24
4 25-32
5 33-40
6 41-48
7 49-56
8 57-64
9 65-72
10 73-80
11 81-88
12 89-96
13 97-104
14 105-112
15 113-120
16 121-128
This parameter can also be changed in remote
mode. The display will look as follows:
Start Group= 01
01 to 16 #=Next
Enter the 2 digit group number, or press then
release # # # # to proceed to the next option. You can
press then release ~ ~ ~ ~ to exit setup mode.
! Total Calls
This is a inbound call counter. It shows the
grand total number of inbound messages left on the
system. This count is not resetable. The display
will look as follows:
- Total Calls -
----00000000----
You can press then release # # # # or ~ ~ ~ ~
to return to MENU. You can access the hidden
setup, while it shows the Total Calls, by entering:
*
* * *, * * * *, * * * *, * * * *, # # # #.
Hidden Setup
Options
The hidden setup contains settings that should
only be changed by experienced users. It is entered,
from the
Total Calls window, in Setup Mode, by
entering: * * * *, * * * *, * * * *, * * * *, # # # #.