SONOSAX SX-62R Quick_Start - Manual (Page 10)

SONOSAX SX62R Quick Start Guide Page 10 of 34
4.2.3 Input Assignment – Linking and Routing
Each input channels can be individually routed and assigned to the stereo mix bus. Input channels can be
configured either as a single MONO channel, as STEREO pair or an M/S pair.
- A [MONO] channel can be freely routed to the mix busses either to the Left [L] bus or to the Right [R] bus
only, or to the center [C] at the same level on the left and right busses, or through the panoramic [PAN] for a
progressive adjustment from Left to Right.
- A stereo pair [ST], such as a stereo microphone, must be always connected as a pair to the input channels
1-2 or 3-4 or 5- 6. Selecting [ST] automatically disables the routing selector [L-C-R-PAN] and route the Odd
channel to the Left mix bus and the Even channel to the Right mix bus. The Fader of the Odd channel is
automatically "Linked" to the Fader of the Even channel. A stereo pair can not be linked to channel 6
- An M/S microphone can be connected onto any pair of input channels 1-2 or 3-4 or 5- 6. Connect the M
channel on the Odd input and the S channel on the Even input. Selecting [M/S] decodes the modulation which
is sent to the mix bus with a 50/50 ratio. The Odd channel is automatically linked to the Even channel. Linking
to channel 6 can not be activated. Varying the spread of the MS pair can be done by slightly adjusting the
input Gain of the S channel. Select [ST] instead of [MS] to send a non decoded modulation to the mix bus.
Select between MONO, ST
or MS mode
If MONO is selected, the
channel can be Linked to
the fader of channel 6 Assign the channel to the
mix bus
If MONO is selected, the
toggle switch selects the
PAN – L – R or C routing
Return to the
Main Menu Active pair
of channel Jump to
channels 3-4 Jump to
channels 5-6
In this example [ST] is
selected
If [ST] or [MS] is selected,
the fader can not be linked
to fader nr 6 Assign the channel to the
mix bus
If [ST] or [MS] is selected
the routing PAN – L – R or
C is disabled
NOTE:
LINK 6 is used for multi-channel systems such as Soundfield microphones, double M-S system or
any Surround microphone system. It links the Faders only, not the Gain trim