SONOSAX SX-62R Quick_Start User Manual

Page 11

Advertising
background image

SONOSAX SX62R

Quick Start Guide

Page 11 of 34

4.3

MASTER & MONITORING SECTION

This section details all functionalities related to the Main output, the dual Monitoring and its communication
system, the stereo Returns, the Slate and Tone generator as well as the COM microphone and the Auxiliary
output




- Main Monitor selector

- Secondary Monitor selector

[BOOM]
Dedicated to the sound operator

dedicated for the Boom or producer

REC: monitors the recorder

REC: monitors the recorder

All other positions monitor the mixer

All other positions monitor the mixer


- Volume control of the main monitor

- Volume of the secondary monitor

[PHONES] on the side and front panels

[BOOM] connector on the back panel



- MIC Level for SLATE & COM send

- MIC Level for COM Return mic

(internal or external microphone)

[BOOM] connector on the back panel



- SLATE Key

- COM Key / Private line communication





- Master Fader of the Stereo Mix

- Stereo RETURN volume control





Monitor selectors choose the source and the monitoring mode as below:

ST :

Monitors the L & R Master Mix in stereo.

REC :

Monitors the Tracks of the Recorder. This selection depends on the configuration in the
[HEADPHONES] menu.

RT:

Monitors the [RETURN] input in stereo

RT/M:

Monitors the [RETURN] input in mono

ST:

same as above, duplicated for quick selection

REC:

same as above, duplicated for quick selection

L:

the Left channel of the Master Mix is listened in Mono on both ears.

R:

the Right channel of the Master Mix is listened in Mono on both ears.

M:

The summing of L & R master channels is eared in Mono. Listening in Mono offer a rapid
check of mono compatibility and helps detecting possible phase problem

MS:

M-S decoder is engaged on the monitoring only

OFF:

Secondary monitor only, its output is powered OFF to save on batteries


NOTE 1:

The MS decoder does not affect the Main outputs. It decodes the MS signal for monitoring
purposes only. The ratio of the MS decoder is set at 50%

NOTE 2:

secondary functions are controlled by specific menus explained in following chapters


Advertising