SP Controls CatLinc - Manual (Page 17)

FCC COMPLIANCE
This equipment generates radio frequency energy and if not installed in
accordance with the manufacturer’s instructions may cause radio interfer-
ence.
This equipment complies with part 15, Subpart J of the FCC rules for a
Class A computing device. This equipment also complies with the Class A
limits for radio noise emission from digital apparatus set out in the Radio
Interference Regulation of the Canadian Department of Communications.
These above rules are designed to provide reasonable protection against
such interference when operating the equipment in a commercial environ-
ment. If operation of this equipment in a residential area causes radio fre-
quency interference, the user and not SP Controls, Inc., will be responsible.
Changes or modifications made to this equipment not expressly approved
by SP Controls, Inc., could void the user’s authority to operate the equip-
ment.
SP Controls, Inc. assumes no responsibility for any errors that appear in this
document. Information in this document is subject to change without notice.
COPYRIGHT
CatLinc™, SmartPanel™, and the SP Controls switch logo are trademarks
of SP Controls, Inc. No part of this document may be reproduced or trans-
mitted in any form or by any means, electronic or mechanical, for any pur-
pose, without express written permission of SP Controls, Inc.
© 20 10 SP Controls, Inc. All rights reserved.
15