4) adding optional 90º elbow (ets only), 5) adding optional corner reflector (ets only) – Space Ray ETS Series User Manual
Page 26
Form 43343300
May 2013
-25-
10.4)
ADDING OPTIONAL 90º ELBOW (ETS ONLY)
1.
The optional 90º elbow must be located a minimum of 10 ft. after the control box.
2.
Hang the tube sections in a 90º ("L") shaped pattern. Allow spacing for the elbow. The distance from one end
of the elbow to the centerline of the opposite leg is 13" as shown.
3.
Join the tube ends of the tube sections and the elbow together and secure with tube couplings as described
in Section 10.1).
90 Deg. Elbow
Tube
Coupling
13 (330mm)
13 (330mm)
Self-Drilling Screws
(QTY-2 per coupling)
10.5)
ADDING OPTIONAL CORNER REFLECTOR (ETS ONLY)
1.
Place the corner reflector over the reflectors of both tube sections.
2.
Secure by sliding speed clips on the reflector edges. One speed clip is required for each side of reflector.
3.
The corner reflector can be used only when the long axis of the heater is level and mounted in a horizontal
position.
Speed Clip
(QTY-4)
Corner
Reflector