Sundance SMT130 v.1.0 - Manual (Page 10)

User Manual (QCF42); Version 3.0, 8/11/00; © Sundance Multiprocessor Technology Ltd. 1999
3 Setting Up the SMT130
The SMT130 should be set up in the following way.
• Turn the system off and add the SMT130 (With TIM already installed) to the PCI-
104 stack. Take care to ensure that all stacking connector pins locate correctly.
Secure the SMT130 in the stack with the pillars and screws provided. Adjust
rotary switch SW1 to ensure that the SMT130 has a unique stack position. No two
cards in the PCI-104 stack must have the same setting. Note only positions 0 to 3
are valid.
• Switch on PC and wait for the OS to boot up.
• Windows 95/98/NT/2000 will detect a new hardware.
• Windows should automatically find the drivers from the CD, if not browse to the
CD or if you downloaded from the ftp site to the folder where you unzipped the
SMT6300 software.
• 3L application software will detect the SMT130 if the SET TISLINK variable is set
to SMT320.
• You can run the SMTBoardInfo application to detect the number of SMT130s in
your system and report their stack positions and I/O addresses. This information
is required when setting up code composer for the board. SMTBoardInfo is part of
the SMT6300 package.