Sundance SMT329 - Manual (Page 50)

6.1.1.4 JTAGIN header sorted by J27 pin number:
This table also shows the connections to a standard 14 pin XDS510 JTAG controller header:
J27 PIN 329 Signal 329
In/Out 329 Source 14 Way
Pin
14 Way
Signal XDS510
In/Out
1 JITDO IN IC26/9 3 TDI OUT
2 0V - - 4 GND
3 JITDI OUT IC27/26 7 TDO IN
4 0V - -
5 JITMS IN IC26/7 1 TMS OUT
6 0V - - 8 GND
7 JITCK IN IC26/8 11 TCK OUT
8 0V - - 10 GND
9 JITCK1 OUT IC27/29 9 (note 2) TCK_RET IN
10 0V - - 12 GND
11 -JITRST IN IC26/6 2 -TRST OUT
12 0V - - (note 1)
13 -JIRESETX IN IC26/5 - - -
14 PD1AMP OUT F5/1 5 PD IN
15 -JIDET IN IC26/4 (note 1) - -
16 -CONFIG IN/OUT IC26/14 - - -
17 JEMU0 OUT IC26/2 13 EMU0 IN/OUT
18 JEMU1 OUT IC26/12 14 EMU1 IN/OUT
19 JIU1 IN/OUT IC26/15 - - -
20 JIU2 IN/OUT IC26/16 - - -
Note1:
-JIDET (pin 15) is wired directly to 0V (pin 12) inside the plug.
Note2:
A 33 Ohm damping resistor must be attached to J27 pin 9, the other end is
then attached to the 14 way cable pin 9 to drive TCK_RET.
User Manual SMT329 Page 50 of 52 Last Edited: 09/02/2007 10:58:00