Super Systems 7EK 31081 - Manual (Page 32)

Appendix A.2
DEFAULT CONFIGURATION PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the typical
values loaded in the instrument prior to shipment from
factory. To load the default values proceed as follows:
a)
The instrument must be in modify configuration mode.
b) By t and s pushbuttons select the "dF.Cn"
parameter.
c) Press s pushbutton to select between table 1
(european) or table 2 (american) default set of
parameters; press FUNC pushbutton the display will
show:
This means that the loading procedure has been initiated.
After about 3 seconds the loading procedure is ended
and the instrument reverts to display the "dF.Cn"
parameter.
d) To return to normal display mode, reach the "End"
parameter and select the "yES" indication,
e) press the FUNC key
PARAMETER TABLE 1 TABLE 2
SEr 1 Ero Ero
SEr 2 1 1
SEr 3 19200 19200
SEr 4 7E 7E
P1 3 21
P2 ----. ----.
P3 0 0
P4 400 1000
P5 rEv rEv
P6 0-20 0-20
P7 0 0
P8 400 1000
P9 nonE nonE
P10 rEL rEL
P11 H.A. H.A.
P12 nonE nonE
P13 H.A H.A.
P14 nonE nonE
P15 H.A H.A
P16 OPrt. OPrt
P17 0 0
P18 0.1 0.1
P19 0 0
P20 0 0
P21 norL norL
P22 norL norL
P23 norL norL
P24 norL norL
P25 Air Air
P26 OFF OFF
P27 rEv rEv
P28 OFF OFF
P29 rEv rEv
P30 OFF OFF
P31 rEv rEv
P32 OFF OFF
P33 0 0
P34 ON ON
P35 2 2
P36 30.0 30.0
P37 1.0 1.0
P38 00.20 00.20
P39 ON ON
P40 0 0
P41 10 30
P42 0 0
P43 0.0 0.0
P44 nOFL. nOFL.
P45 nOFL. nOFL.
P46 Pid Pid
P47 0 0
P48 10 10
P49 Fn.Sp Fn.Sp
P50 0 0
P51 diS diS
P52 50 50
P53 10.00 10.00
P54 10 10
P55 0 0
31081-A-00.p65 3/24/00, 11:59 AM 2