Super Systems DAQ - Manual (Page 18)

Super Systems Inc. Page 18 of 34 DAQ Operations Manual
Host 485 Address
This option will allow the user to set the Host 485 address. The range is 1 through 249.
Slave 1 (5,6) Baud
This option will allow the user to set the Slave 1 baud rate. The options are:
1200 19200 115200
2400 28800
4800 38400
9600 57600
14400 76800
IP Address/IP Mask/IP Gateway
These options will allow the user to change the various IP addresses of the DAQ. Contact Super
Systems Inc at 800-666-4330 or your IT department for help in changing any of these addresses.
Note: Once the IP address has been changed, communications with the DAQ will be lost until
the correct IP address is entered on the System Management screen (Step 3: Configure
Configurator 2.0 on the local computer section above) . Clicking on any of these options will
allow the user to change all of the options at once.
Device Configuration
The Device Configuration menu option will allow the user to change certain configuration
options on the DAQ. Currently, the only option to change is the Temperature Mode option.
Temperature Mode
This option will allow the user to change the mode of the temperature. The options are °F or
°C.