Venstar T2900 - Manual (Page 46)

Page 9.4
9
Adjusting the Humidification Setpoint
HUMIDITY
NOTE: Each step # is located at
the top right corner of the
display for easy reference.
If your HVAC unit is equipped with a humidification system and
the Humidity Module has been installed, the thermostat will provide
power to the appropriate terminal on the backplate of the thermostat
when the humidity in the home falls below the setpoint you have
chosen. The value for this setpoint ranges from 0% to 60%.
You cannot set the dehumidify setpoint any lower than the humidify setpoint; a
5% differential is forced between the humidify and dehumidify setpoints.
Press the HUMIDITY
button to enter the
Humidity Setup screen.
Humidification Notes: Press the button to set the humidity
setpoint to 0% for no humidification operation.
NOTE: Due to variations in environmental conditions, it is not always possible
to achieve the desired humidification or dehumidification setpoint.
Press the HUMIDITY button to leave the
Humidity Control screens (if no buttons are
pressed, the display will leave the Humidity
Control screens after 30 seconds).
Adjust the desired
humidification setpoint
(0%-60%) Press
HUMIDITY
Current Room Humidity
Humidify
Setup
0
1
rh
40