Venstar T2900 - Manual (Page 91)

Page 19.3
How to Set and Reset the UV Light
Run-Time Alert
This counter keeps track of the number of days since the UV Light
counter has been reset. The UV Light icon will appear after the
number of days has been achieved, as shown in step #46 (below).
Setting the counter to zero in Step #46 will prevent the Service UV
Light icon from ever appearing.
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
(0 - 1990 days)
UV Light
Setup
Service
PROGRAM
MODE
MODE
Reset the counter to 0 to
remove the Service UV
Light icon from the display.
Press
FAN
UV Light
Setup
Service
Days since the UV Light
icon has been reset
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Adjust the number of days
in increments of 10 before
the UV Light icon appears
on the display. 0 = off.
19
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens.
MODE
Press the MODE button repeatedly
until this setup screen appears.
18 0
46
0