Venstar T2900 - Manual (Page 51)

Page 10.5
Using the Reheat Function
If Reheat operation is
desired during the dehum-
idification process select
On; otherwise select Off.
On
Off
This feature allows the thermostat to turn on Electric Heating (W2)
during Cool to Dehumidify to maintain room temperature until the
dehumidification setpoint is reached. The cooling cycle will allow for
the dehumidification of the air to occur while the Electric Heating will
allow for a constant room temperature. If Reheat is enabled the Aux
icon will appear on the display during Cool to Dehumidify operation.
H EAT
OFF
DeHumidify
Setup
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
Dehumidification Notes: Reheat is only available if Cool to
Dehumidify has been set to ON in step #10 (see page 10.4).
Step 12 appears only if step 10 is set to “ON” and if the
Dehumidification setpoint is not 99% (see page 10.3).
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens.
10
rE
12