Verilink 9000 Series (34-00271) Product Manual - Manual (Page 422)

400 C HAPTER A: C ONSOLE I NTERFACE
Unisys
Poll/Select
Terminal Port
Parameters
(a) Link Speed (baud): Asynchronous: 300, 1200, 2400, 4800, 9600, or 19200 bps
Synchronous:
1200, 2400, 4800, 7200, 9600, 12000, 14400, 16800,
19200, 24000, 28800, 38400, 56000, or 64000 bps
(b) Character Length: 7 or 8 bits
(c) Parity: None, Even, or Odd
, (Even for Asynchronous or TDI; Odd for Synchronous)
(d) Link Interface: V35 Async, V35 Sync, RS232 Async, RS2332 Sync, TDI
(e) Link Termination: DCE or DTE
(f) No. of Trailing PADs: 0 to 255, 2
(g) No. Char. before Tx: 1 to 4096
(h) Turn Around: 0 to 10 (in 10-millisecond increments)
(i)
P/S Timeout:1 to 65535 (in 10-millisecond increments), 30
(j) Msg Timeout:1 to 65535 (in 10-millisecond increments), 50
(k) RTS/CTS Control: Dynamic, Fixed On, or Floating
(l)
Drop DTR on DCD: Yes or No
(m) Link Active: DSR & DCD, DSR Only, Don’t Care, 3
(n) Offline Count: 1 to 255 non-answered polls or selects, 3
(o) Offline Retry: 1 to 255 seconds, 30
(p) Select between Poll: 1 to 255 select sequences, 2
(q) Select Retry Delay: 1 to 255 seconds, 10
(r) Algorithm: Specific Poll, Contention, or Group Poll
(s) Count: 1 to 255 contention sequences, 10
(t)
Delay: 1 to 65535 (in 10-millisecond increments), 1000
(u) Connect to Controller: Yes or No
(v) Activity Timer: 0 to 255 minutes
(w) Address List (a) Term Ad: two displayable ASCII characters
(b) Term Name: up to 17 ASCII characters, null string
(c) Default Address: two displayable ASCII characters
(d) Default Name: up to 17 ASCII characters, null string
(e) Transmission Number: None, Sequential, Toggle, or tRansparent
(If Sequential or tRansparent, Xmit Number Length: 1 to 3)
(f) Options: Automatic Connection on Power On (Y or N) ?
Don’t Send Status Messages (Y or N) ?
Reserved Channel (Y or N) ?
Sharable (Y or N) ?
Virtual Address (Y or N) ?
Send CR on Input (Y or N) ?
Don’t Send ESC K on Input (Y or N) ?
Station Not Pollable (Y or N) ?
Group Address (Y or N) ?
Keep Message (Y or N) ?
Wait for Host Connection (Y or N) ?
Virtual Address (Y or N) ?
Print Spooler (Y or N) ?
Flush Input for Unknown Address (Y or N) ?
Send Disconnect Message (Y or N) ?
Defaults are underlined.