Westermo GDW-11 - Manual (Page 216)

216 GPRS commands 6615-2220
+CGQREQ – Requested Quality of Service Profile
Description:
This command allows the TE to specify a Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.
The command specifies a profile for the context identified by the local context identifica-
tion parameter, <cid>. Since this is the same parameter that is used in the +CGDCONT
command, the +CGQREQ command is effectively an extension to the +CGDCONT
command. The QoS profile consists of a number of parameters, each of which may be set
to a separate value.
A special form of the command, +CGQREQ= <cid> causes the requested profile for
context number <cid> to become undefined.
The command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports
several PDP types, the parameter value ranges for each PDP type are returned on a
separate line.
Syntax:
AT+CGQREQ=[<cid> [,<precedence > [,<delay> [,<reliability.> [,<peak> [,<mean>]]]]]]
Response Syntax:
AT+CGQREQ?
+CGQREQ: <cid>, <precedence >, <delay>, <reliability>, <peak>, <mean>
[+CGQREQ: <cid>, <precedence >, <delay>, <reliability.>, <peak>, <mean>
[. . .]]
AT+CGQREQ=?
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list of supported <delay>s),
(list of supported <reliability>s) , (list of supported <peak>s), (list of supported
<mean>s)
[+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list of supported
<delay>s), (list of supported <reliability>s) , (list of supported <peak>s), (list of sup-
ported <mean>s) [. . .]]
Parameters:
<cid>
Numeric parameter that specifies a particular PDP context definition.
Range of values is 1 to 3