Westermo GDW-11 - Manual (Page 239)

GPRS commands 239 6615-2220
+CGPADDR – Show PDP address
Description:
The execution command returns a list of PDP addresses for the specified context identi-
fiers. The test command returns a list of defined <cid>s
Syntax:
+CGPADDR=[<cid> [,<cid> [,. . .]]]
Response Syntax:
+CGPADDR: <cid>,<PDP_addr>
[+CGPADDR: <cid>,<PDP_addr>
[...]]
AT+CGPADDR=?
+CGPADDR: (list of defined <cid>s)
Parameters:
<cid>
A numeric parameter which specifies a particular PDP context definition. If no <cid> is
specified, the addresses for all defined contexts are returned.
<PDP_address>
A string that identifies the MT in the address space applicable to the PDP. The address
may be static or dynamic. For a static address, it will be the one set by the +CGDCONT
command when the context was defined. For a dynamic address it will be the one
assigned during the last PDP context activation that used the context definition referred
to by <cid>. <PDP_address> is omitted if none is available.
Command example Possible responses Note
AT+CGPADDR=1 +CGPADDR=1,"107.210.5.4"
OK
AT+CGPADDR=? +CGAPDDR: (1,2,4) Possible values
OK
AT+CGPADDR +CGPADDR: 1,
+CGPADDR: 2,"10.3.73.151"
+CGPADDR: 4,