Alinco DJ-V57 - Manual (Page 17)

2.Accessories
2
17
Charging the Battery Pack Using DC-Jack on the Unit
The unit can charge the EBP-65 and EBP-66 optional Ni-MH battery packs by
supplying DC power through the DC-jack on the unit using EDC-146/147/148 wall
chargers or an optional DC power supply (DC 12V~DC 16V, 1A or more: IEC/EN
60950-1 compliant) and a DC cable such as EDC-37.
1. Attach the battery pack by referring to "Battery Pack" (page 15).
2. Connect the AC adapter plug to the DC-jack on the
unit then connect the charger's adapter to the wall
outlet.
* AC adapter may look different.
3. Turn on the unit and set the battery charge
parameters. (page 44)
* "Battery Type Setting"
Select BAT-NI+.
4. After completing the settings, a flashing
appears on the display. Make sure the icon is
flashing then turn off the unit. It takes about 10
hours/30hours for EBP-65/66 respectively to
complete the charge.
AC adapter plug
AC adapter*
■
NOTE:
• Please read the general safety instructions included in the optional accessories
to correctly and safely use them.
• EDC-146/147/148 can't be used as the adapter for operation. These adapters
are for charging purposes only.
• Chargers can't perform the correct charge when the AC voltage is unstable.
•
flashes even EBP-65/66 aren't attached. To avoid short-circuit, never
activate this function when the pack isn't attached to the unit.
• Li-ion battery packs can't be charged in this way.