Alinco DJ-V57 - Manual (Page 33)

5.Useful Functions
5
33
5. Useful Functions
The scan function automatically searches the receiving signals. There are 2 modes for
scan-resume condition.
• Busy Scan: The scan stops when a signal is detected, stays until the signal is gone
then resumes scanning.
• Timer Scan: The scan stops when a signal is detected, and resumes scanning after 5
seconds regardless of receiving status (TIMER1 setting).
During scanning, the 1MHz decimal point ( ) on the frequency display flashes.
Press any key other than the MONI key to stop scanning.
Scanning starts in the direction of the last dial operation (up or down).
5.1.1 VFO-Scan
1. Use the key to select the VFO mode.
2. Press the key to start scanning. The unit scans in accordance with the order
of one step.
3. Rotate the dial clockwise/counter-clockwise to change the scan direction.
VFO-scan scans the entire frequency range.
4. Press any key other than the MONI key to stop scanning.
5.1.2 Memory-Scan
1. Use the key to select the Memory mode.
2. Press the key to start memory scanning.
3. Rotate the dial clockwise/counter-clockwise to change the scan direction.
Memory-scan scans all programmed memory channels.
4. Press any key other than the MONI key to stop scanning.
NOTE:
Please set the squelch level correctly before scanning, even in the TSQ scanning the
normal squelch level adjustment is required to activate this function.
NOTE:
Please refer to the Set mode to switch the setting between Timer and Busy scan modes
(page 46).
Scan Modes 5.1