Alinco DJ-V57 - Manual (Page 42)

7.Special Functions
7
42
7. Special Functions
1. In the VFO/Memory/Call channel mode, select the channel to which you wish to
apply the Repeater-Access setting.
2. Press the FUNC key, and while is displayed on the LCD, press the key.
The Repeater-Access setting is applied to the operating frequency.
Reverse operation is possible by pressing the key.
The repeater function releases temporary and you can transmit on the frequency
originally used for the repeater downlink while monitoring the uplink frequency.
Press again to go back to the normal repeater mode.
The icon flashes during the reverse operation.
This is a type of VFO scan, but by setting the frequency range of the VFO into PH and
PL channels, it only scans between those frequencies.
With setting the PH and PL properly, up to 3 Program scan ranges will be available.
1. Enter the Memory mode and set the PL and PH
frequency into the designated memory channels.
Refer to Memory setting for the proper sequence.
2. Return to VFO mode by pressing key. Set
the VFO to the frequency within the range to be
program-scanned.
3. Press the key to start scanning.During this
scan mode, "P" flashes after memory channel
display.
4. Press any key other than the MONI key to stop
scanning.
PH
PL
The Lowet band edge
The Highest band edge
Range (1)
(2)
(3)
Program Scan 7.2
NOTE:
Preset parameters on the Repeater-Access function memory will be effective at
any frequency. Repeater-Access parameters have priorities over the parameters
programmed in the VFO/memory/CALL modes.
Repeater-Access 7.1