Alinco DJ-V57 - Manual (Page 30)

4.Basic Operation
4
30
4.6.6 Programming a Repeater-Access Function Setting
The "Repeater-Access" function is to set the desired shift and tone parameters to the
current operating frequency by just 2 key-touches.
Please set the parameters to be applied to the Repeater-Access function here.
1. Enter the Memory mode (by pressing the key if necessary).
2. Rotate the dial to select MrpV-SET (VHF band) or MrpU-SET (UHF band).
3. Set the most commonly used Repeater-Access parameters by referring to "Repeater-
Access" (page 42). The parameters can be programmed in this memory are marked *
in the chart below. By activating the Repeater-Access function these settings are
applied to the operating frequency regardless of the VFO/Memory/CALL modes, by
temporary replacing the current parameters.
4. After programming is completed, press the FUNC key then press the key
while MrpV(U)-SET is displayed to store the edited parameters.
5. Rotate the dial to operate in the Memory mode by selecting channels or press the
key for VFO mode operation.
6. To operate with repeater-access, please refer page 42.
4.6.7 Programmable Parameters in Memory Channels
The following parameters can be stored in each of the memory channels.
• Frequency • Offset frequency *
• Skip channel setting • Shift direction (+/-) *
• Busy channel lockout (BCLO) • Tone encoder frequency *
• Transmission power (H/M/L) • Tone decoder frequency *
• Battery save setting • Tone encoder/decoder setting (TSQ) *
• Clock Shift setting • DCS code *
• Alphanumeric channel tag • DCS setting *
• ATT Level • WFM/NFM setting
NOTE:
Only parameters marked "*" are programmable in Repeater-Access function memory.
NOTE:
• You can not communicate in the MrpV(U)-SET setting channel.
• The MrpV(U)-SET channel is skipped during scanning. You can not delete or
convert this memory to other purposes.