Alinco DJ-V57 - Manual (Page 51)

8.Set Mode
8
51
The DTMF Timing Chart
8.3.17 Menu17 Stand-by Beep/DTMF Setting
By activating this function, a short beep or DTMF tone code sounds to indicate that
your transmission is end.
1. STB-OF is displayed on the LCD.
2. Rotate the dial to switch the display as shown below.
• STB-BE
Short beep sounds to indicate that your transmission is end.
• STB-DT
The DTMF tones can be transmitted at the end.
Write the DTMF tones in "M St" of the Auto Dialer memory.
Please refer to "Programming the Auto Dialer Memories" (page 40)
STB-OF STB-BE STB-DT
PTT ON DTMF code DTMF code DTMF code
WAIT Time First Digit
Burst Time
Pause
Time
Burst
Time
Pause
Time
Burst
Time