Alinco DJ-V57 - Manual (Page 28)

4.Basic Operation
4
28
This mode allows recalling and operating the preprogrammed frequency or setting in
the memory channels. This unit provides up to 200 memory channels, 2 CALL
channel (VHF/UHF), 2 Repeater-Access function memory (VHF/UHF), 10 Transmitter
Detecting Function memory and 2 Program scan edge memory (VHF/UHF).
4.6.1 How to Program Memory Channel(s)
1. Select a frequency and operating parameters to be programmed in the VFO mode.
Programmable parameters are explained later. Press the key. " " appears
on the display.
2. Press the FUNC key to display .
3. Rotate the dial to select the desired memory channel number while is displayed. An
empty channel is shown with a flashing " ". "V-SET (U-SET)" is explained later.
4. By pressing the key again while is on the display, a beep sounds and
programming is completed.
5. Pressing the FUNC then key while is displayed on the programmed
channel will delete the memory data and it becomes available for reprogramming.
4.6.2 Recalling a Memory Channel
1. Select the Memory mode by pressing the key. " " and channel number
appear on the display to indicate that the unit is in the Memory mode.
Repeat to switch between the Memory and VFO modes.
2. Select a memory channel.
Rotating the dial will increase or decrease a memory channel number.
4.6.3 Deleting a Memory Channel
1. Select the Memory mode by pressing the key.
2. Rotate the dial to select the memory channel No. that you wish to delete.
3. Press the FUNC key, and while is displayed on the LCD, press the key. A
beep sounds, then " " flashes on the display.
Memory Mode 4.6
NOTE:
• Over writing new data is always permitted. It's not necessary to delete the old
data before overwriting.
• When " " is flashing in step 3 (when the memory contents are displayed as
is on the display), it is still possible to cancel the operation by pressing the
FUNC key, and while
is displayed on the LCD, press the key. After
changing channels or modes, this is no longer possible.